Installation
2. Insert solid end of Quicksilver Alignment Tool
through bearing in gimbal housing and into input
shaft splines of bearing support.
1.
Install bearing support assembly (tailstock) on
transom plate using hardware as shown. Tighten
bolts until snug. DO NOT TORQUE BOLTS AT
THIS TIME.
IMPORTANT: The spherical washers MUST BE
positioned so that the rounded side of the wash-
ers are toward the bearing support assembly as
shown.
b
a
g
h
a
b
d c
e
f
75279
71401
Typical Stern Drive Unit Shown
a - Bolts 1/2-20 x 4 In. (102 mm) Long
b - Steel Washer (Flat)
c - Spherical Washer (Rounded On One Side)
d - Bearing Support
a - Quicksilver Alignment Tool
b - Insert This End Of Alignment Tool Through Gimbal Hous-
ing Assembly
e - Spherical Washer (Rounded On One Side)
f - Nut 1/2-20
g - Transom Plate
3.
DO NOT remove alignment tool from gimbal
housing.
h - Bearing Support (Tailstock)
!
CAUTION
Both attachingboltsMUSTBEstruckfirmlyinthe
following step to properly seat spherical wash-
ers. If procedure is not followed, difficulty in the
installation of the stern drive may be experienced
and subsequent damage to input bearing may re-
sult.
Index
8E-8 - DRIVE SHAFT / PROPELLER SHAFT MODELS
90-823224--2 796
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 454 CID, Mercury MerCruiser 502 CID |
| Model Year | 1993, 1994, 1995, 1996, 1997 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(4 votes, average: 4.5 out of 5)
Marine readers have rated 1993 1997 Mercury-MerCruiser GM V8 454 CID 7.4L and 502 CID 8.2L Marine Engines Service Manual Number 16 4.5 out of 5.0 based on 4 product reviews. Hugely helpful service manual! Perfect. Thank you!
Manuals are all Important for Technician
This book is invaluable if you do your own repairs. Great book.
Could not find a copy until a search brought me here.
Excellent print.
Thank you