DUAL CABLE - REAR ENTRY
Checking Transmission
Fluid Level
IMPORTANT: Use only specified transmission
fluid (see “Lubricants/Sealants”).
e
IMPORTANT: The dipstick to check fluid level is
located on the port side of transmission. DO NOT
remove T-handle on starboard side of transmis-
sion.
Check transmission fluid before starting engine each
day, as follows:
1.
Remove dipstick. Check fluid level as indicated
on dipstick. Fluid level may be somewhat over full
mark, as some of the fluid from transmission fluid
cooler and hoses may have drained back into
transmission. If low, add transmission fluid to
bring level up to full mark on dipstick.
72960
c
b
a
1
27661
d
2
Typical Hurth Transmission Shown
50073
b
1
2
- Cable Barrel Stud
- Cable End Guide Stud
IMPORTANT: To accurately check fluid level, en-
gine must be run at 1500 RPM for two minutes im-
mediately prior to checking level.
a - Cable End Guide
b - Locknut and Washer (Tighten Until Bottoms Out, Then
Back Off 1/2 Turn)
c - Spacer (Fits Over Bushings)
d - Bushing
2.
Start engine and run at 1500 RPM for two min-
utes to fill all hydraulic circuits.
e - Cable Barrel
f - Spacers (Fits Over Stud)
IMPORTANT: Be sure to push dipstick all the way
down into dipstick tube when checking fluid lev-
el.
3.
Stop engine and quickly check fluid level. Add
automatic transmission fluid, if necessary, to
bring level up to full mark on dipstick. (Refer to
“Filling Transmission,” following.)
4.
Reinstall dipstick.
Index
90-823224--2 796
HURTH V-DRIVE TRANSMISSION -8D-7
Product Specification
Categories | Mercury MerCruiser Manuals |
---|---|
Tags | Mercury MerCruiser 454 CID, Mercury MerCruiser 502 CID |
Model Year | 1993, 1994, 1995, 1996, 1997 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
Hugely helpful service manual! Perfect. Thank you!
Manuals are all Important for Technician
This book is invaluable if you do your own repairs. Great book.
Could not find a copy until a search brought me here.
Excellent print.
Thank you