9.
Place remote control shift lever in the reverse
gear position. Check that transmission is fully in
gear, following same procedure.
10.
If transmission shift lever will position properly in
one gear, but not in the other, recheck shift cable
adjustment. If transmission shift lever will not
position properly in both gears, move transmis-
sion shift lever stud (a), from top hole in shift
lever, to bottom hole, and recheck for proper
positioning. If proper positioning is still not
obtained, remote control does not provide
sufficient shift cable travel and must be re-
placed.
e
b
73589
c
d
CABLE
BARREL
STUD
c
a
b
e
50228
CABLE
END GUIDE
STUD
a - Shift Lever Stud (In Bottom Hole, If Required)
b - Lever, in Neutral Detent, Must Be Approximately
10° Aft of Vertical
c - Shift Lever Top Hole
a
f
11.
12.
Reattach locknut and washer to cable end guide
stud. Tighten until snug, then back off one-half
turn.
b
71210
Typical Single Cable - Forward Entry
Reattach locknut and washer to cable barrel
stud. Tighten until they bottom out. Tighten se-
curely, but do not overtighten.
a - Cable End Guide
b - Locknut and Washer
c - Spacer (Fits over Bushings)
d - Bushings
e - Cable Barrel Location
f - Spacer (Fit over Stud)
NOTE: To change cable approach direction on
single or dual station installations, only the spacers/
bushings have to be switched to the opposite stud
(the studs are identical).
Index
2D-12 –MIE MODELS - HURTH TRANSMISSIONS
90-823224--2 796
Product Specification
Categories | Mercury MerCruiser Manuals |
---|---|
Tags | Mercury MerCruiser 454 CID, Mercury MerCruiser 502 CID |
Model Year | 1993, 1994, 1995, 1996, 1997 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
Hugely helpful service manual! Perfect. Thank you!
Manuals are all Important for Technician
This book is invaluable if you do your own repairs. Great book.
Could not find a copy until a search brought me here.
Excellent print.
Thank you