2.
3.
4.
Place remote control shift lever, and transmission
shift lever, in neutral position.
IMPORTANT: Transmission is fully in gear when
shift lever comes to a stop, in either direction.
Remove nuts and washers from shift cable at-
taching studs.
7. Place remote control shift lever in forward gear
position. Check to ensure transmission is fully in
gear, as follows:
Locate center of remote control and control shift
cable play (backlash), as follows:
a. Hold shift lever in position.
b. Carefully slide shift cable off of anchor points.
c. Attempt to move shift lever further.
a. Check that remote control is in neutral posi-
tion.
b. Push in on control cable end with enough
pressure to remove play, and mark position
(a) on tube.
8.
Place remote control shift lever in reverse gear
position and again check to ensure transmission
is fully in gear as follows:
c. Pull out on control cable end with enough ef-
fort to remove play, and mark position (b) on
tube.
a. Hold shift lever in position.
b. Carefully slide shift cable off of anchor points.
c. Attempt to move shift lever further.
d. Measure distancebetweenmarks(a)and(b),
and mark position (c), halfway between
marks (a) and (b).
9.
If transmission shift lever will position properly in
one gear, but not in the other, recheck shift cable
adjustment. If transmission shift lever will not po-
sition properly in both gears, move transmission
shift lever stud, from top hole in shift lever to bot-
tom hole, and recheck for proper positioning. If
proper positioning is still not obtained, remote
controldoesnotprovidesufficientshiftcabletrav-
el and must be replaced.
b
c
c
a
b
72603
5.
6.
Center cable-end play, then adjust cable barrel to
align holes in barrel and in cable end guide with
attaching points on transmission.
c
Temporarily install shift cable. Do not secure at
this time.
a
50228
a - Shift Lever Stud (In Bottom Hole, If Required)
b - Lever In Neutral Position, Must Be Approximately 10 De-
grees Aft Of Vertical
c - Shift Lever Top Hole
Index
90-823224--2 796
HURTH DOWN ANGLE TRANSMISSION - 8C-5
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 454 CID, Mercury MerCruiser 502 CID |
| Model Year | 1993, 1994, 1995, 1996, 1997 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(4 votes, average: 4.5 out of 5)
Marine readers have rated 1993 1997 Mercury-MerCruiser GM V8 454 CID 7.4L and 502 CID 8.2L Marine Engines Service Manual Number 16 4.5 out of 5.0 based on 4 product reviews. Hugely helpful service manual! Perfect. Thank you!
Manuals are all Important for Technician
This book is invaluable if you do your own repairs. Great book.
Could not find a copy until a search brought me here.
Excellent print.
Thank you