SERVICE MANUAL NUMBER 24
IGNITION SYSTEM
Installation
1.
2.
Align rotor, housing and intake manifold using scribe marks.
Slowly lower distributor (with gasket) through intake manifold and into position. If distrib-
utor shaft won’t drop into position, pull it out and insert a screwdriver into the hole to turn
the oil pump drive shaft. Repeat this adjustment as many times as needed until the dis-
tributor can be firmly seated and all components are in alignment.
3.
Install hold-down clamp over distributor and bolt it securely to engine surface. Torque
bolt to 30 lb-ft (40 Nm).
4.
5.
Install distributor cap and secure in place with two screws.
Connect electrical connectors to module.
IMPORTANT: Before proceeding to the following step, be certain that engine will
obtain an adequate supply of water for cooling. Refer to SECTION 6A, “Seawater
Cooled Models.”
6.
Start engine and check timing.
90-861327--1
OCTOBER 1999
Page 4B-29
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 305 CID, Mercury MerCruiser 350 CID |
| Model Year | 1998, 1999, 2000, 2001 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 4 out of 4)
Marine readers have rated Mercury MerCruiser Engines Service Manual Number 24 GM V-8 305 CID 350 CID 4.0 out of 4.0 based on 1 product reviews. Great performance engine.
Class 1