MIE MODELS
SERVICE MANUAL NUMBER 24
Installation and Alignment
1.
Follow instructions “a” or “b”:
a. Engine mount(s) or adjustment WAS NOT DISTURBED during engine service:
Proceed to following Step 2.
b. Engine mount(s) or adjustment WAS DISTURBED during engine service:
IMPORTANT: Engine mounts must be adjusted, as explained in the following, to
center mount adjustment and establish a uniform height on all mounts.
Ensure that all mounts are:
(1.)
(2.)
In the center of their up-and-down adjustment.
Mounting hole, which is a slot, is forward (if so designed; 350 Magnum Tourna-
ment Ski rear mount does not have a slotted hole).
(3.)
(4.)
Large diameter of mount trunnion extended as shown.
Each mount base is downward. Tighten clamping screws and nuts slightly to pre-
vent moving in or out. Mounts must be free to pivot when installing engine.
e
e
c
a
a
c
g
g
d
f
b
b
f
70140
70645
Front Mount
a- Locking Nut
b- Adjusting Nut
Rear Mount
c- Trunnion Clamp Screw(s) And Nut(s), With Lockwasher(s)
d- Slot Forward
e- 3/8 in. +1/16 in. (10 mm +2 mm)
f - 2-5/8 in. + 1/16 in. (67 mm + 2 mm)
g- Mount Trunnion
CAUTION
Center lifting eye (located on top of thermostat housing) is used for engine align-
ment only. DO NOT use to lift entire engine.
CAUTION
DO NOT allow lifting sling to hook or compress engine components or damage to
them will occur.
Page 2B-6
90-861327--1 OCTOBER 1999
Product Specification
Categories | Mercury MerCruiser Manuals |
---|---|
Tags | Mercury MerCruiser 305 CID, Mercury MerCruiser 350 CID |
Model Year | 1998, 1999, 2000, 2001 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
Great performance engine.
Class 1