IGNITION SYSTEM
SERVICE MANUAL NUMBER 24
Installation
NOTE: Rotor/sensor wheel are sold as an assembly only.
1.
Ensure that carbon brush tang has a 1/4 in. (6 mm) gap between rotor and tang.
a
72731
a - 1/4 in. (6 mm)
2.
3.
4.
Put 2 drops of Loctite 27131 into the rotor so it lands on the locating key.
Put 2 drops of Loctite 27131 in keyway on upper portion of distributor shaft.
Immediately install rotor assembly onto distributor shaft.
a. Ensure rotor locating key is aligned with keyway in distributor shaft. Press rotor down
on the shaft with your hand until it stops.
5.
Let Loctite cure overnight with distributor in inverted position.
IMPORTANT: The rotor should fit very tight. It may be necessary to heat rotor with
heat lamp to properly install. Do not let any Loctite run down distributor shaft. Loctite
could get into top distributor housing bushing.
IMPORTANT: Ensure that the fingers of the sensor wheel are not touching the sensor
when the wheel is rotated.
c
b
a
76395
a - Adjusting Screws
b - Sensor
c - Sensor Wheel Fingers
6.
Reinstall distributor cap on distributor.
Page 4B-20
90-861327--1 OCTOBER 1999
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 305 CID, Mercury MerCruiser 350 CID |
| Model Year | 1998, 1999, 2000, 2001 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 4 out of 4)
Marine readers have rated Mercury MerCruiser Engines Service Manual Number 24 GM V-8 305 CID 350 CID 4.0 out of 4.0 based on 1 product reviews. Great performance engine.
Class 1