STARTING SYSTEM
SERVICE MANUAL NUMBER 24
Maintenance
WARNING
DO NOT use jumper cables and a booster battery to start engine. DO NOT recharge
a weak battery in the boat. Remove battery and recharge in a well ventilated area
away from fuel vapors, sparks or flames.
WARNING
Batteries contain acid which can cause severe burns. Avoid contact with skin, eyes
and clothing. Batteries also produce hydrogen and oxygen gases when being
charged. This explosive gas escapes fill/vent caps and may form an explosive at-
mosphere around the battery for several hours after it has been charged; sparks or
flames can ignite the gas and cause an explosion which may shatter the battery and
could cause blindness or other serious injury.
Safety glasses and rubber gloves are recommended when handling batteries or fill-
ing electrolyte. Hydrogen gases that escape from the battery during charging are
explosive. When charging batteries, be sure battery compartment, or area where
batteries are located, is well vented. Battery electrolyte is a corrosive acid and
should be handled with care. If electrolyte is spilled or splashed on any part of the
body, immediately flush the exposed area with liberal amounts of water and obtain
medical aid as soon as possible.
CAUTION
To prevent damage to the electrical system be sure to adhere to the following:
•
When installing battery, be sure to connect the positive (+) battery cable to
positive (+) battery terminal first and then the negative (–) battery cable to
negative (–) battery terminal.
•
•
Never disconnect the battery cables while the engine is running.
If a charger or booster is to be used, be sure to connect it in parallel with ex-
isting battery (positive to positive and negative to negative).
•
When applying a booster charge to battery, disconnect both cables from bat-
tery (to prevent damage to voltage regulator).
•
•
Check battery condition periodically.
Make sure that battery leads are kept clean and tight.
PERIODIC INSPECTION
1.
2.
3.
Inspect terminals for corrosion and loose connections.
Inspect wiring for frayed and worn insulation.
Check starter mounting bolts for tightness.
Index
Page 4A-6
90-861327--1 OCTOBER 1999
Product Specification
Categories | Mercury MerCruiser Manuals |
---|---|
Tags | Mercury MerCruiser 305 CID, Mercury MerCruiser 350 CID |
Model Year | 1998, 1999, 2000, 2001 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
Great performance engine.
Class 1