Repair instructions
Method 2
1
2.
The gear length is fixed at 5.85 mm (0.230"). Add
3. Insert the 0.2 mm (0.008") shim (1) in the propeller
or subtract the plus or minus marking of the gear
bearing housing. This is a value of experience.
wheel. Subtract from this sum the sum of the ‘F’ and
‘
G’ measurements. The sum thus obtained denotes
the thickness of the shim.
NOTE! On some gear housings for instance the fig-
ures 03 can be stamped or some other figure. In
these cases add the number 5.00 to that of the
‘
‘
F’-measurement and the figure 1.00 to that of the
G’-measurement. Then the ‘F’-measurement ends
up being for instance 5.03 or some other measure-
ment above 5 mm and the ‘G’-measurement for in-
stance 1.03 or some other measurement above 1.0
mm*.
If the sum obtained does not coincide with available
shims, select the closest five – or ten – number. How
to calculate the shim thickness can be seen in the
following example:
Measurement ‘F’
*
4.97 (0.195") stamped
+0.98 (0.039") stamped
4.
Install the propeller shaft along with bearings in the
Measurement ‘G’
*
gear housing. Be careful so that the bearing does not
end up obliquely in the bearing housing or that the
sealing rings are damaged. Make sure that the six
holes in the washer coincide with the screws. Insert
the nuts before the bearing is pushed home complete-
ly in the bearing box. Tighten the six nuts.
5.95
(0.234") 5.95
Gear wheel
5.85 (0.230") fixed
Gear wheel marking
+0.04 (0.002") etched**
5.89
....
5.89
Calculated sum always positive!
0.06 (0.002")
As per this example a 0.05 mm (0.002") shim is in-
serted between the propeller bearing box and the
propeller thrust bearing. Carry on according to points
4–12
below!
*
These measurements are examples.
**
Only the figure 4 is etched on the gear wheel
95
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok