Repair instructions
5.
Use a small amount of water resistant EP bearing
grease, Volvo Penta part no. 1161246-2, to retain the
needle bearings in the cap. Push the spider through
the yoke in one direction to allow the needle bearing to
align with the spider. Push the needle bearing cap into
the yoke with the spider inside the needle bearing cap
to keep the needle bearings in place. Press the needle
bearing cap into the yoke far enough to allow the lock
ring to be installed. Install the remaining needle
bearing caps in the same manner.
WARNING! Be extremely careful when pressing
the needle bearing caps into place. The needle
bearings may come loose and fall to the bottom
of the bearing cap. DO NOT force the needle
bearing caps onto the spider. If the locking
groove for the needle bearings caps do not
readily align, a bearing may have come loose
and fallen to the bottom of the cap.
63
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok