Repair instructions
Assembly, models
290A, SP and DP
9991801
884933
NOTE! When assembling the upper gear housing it is
very important that the gears are correctly positioned
in relation to each other. This applies not only to the
backlash between the gear teeth but also to the gear
teeth contact. Correct gear teeth contact spreads the
load to which the gears are subjected over a larger
area of the gear tooth. This preventing gear break-
down and abnormal wear and at the same time provid-
ing a quiet operation.
884938
17.
When replacing the outer bearing races, the bear-
ing races must be pressed out. Use special tool
handle with 884938 and 884933 holding fix-
9991801
ture. If necessary, recondition the universal joint. See
chapter Reconditioning the universal joint, pages
62–63.
884932
1.
Install the outer bearing race. Use special tool no
884932
.
NOTE! Make sure that the double bearing box is posi-
tioned horizontally. Turn the special tool when install-
ing the other bearing race.
50
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok