Repair instructions
9991801
884312
8.
Remove the recessed washer and the shims in it.
7.
ring and the gear housing as follows:
Measure the shim thickness between the clamp
Press the new sealing ring against the collar in the
double bearing box, with the open part against the
bearing. Use special tools 9991801 and 884312.
Hold the double bearing box as indicated in the picture
with its calculated number of shims (see point 16,
page 39).
NOTE! The guide pin! Add a sufficient number of
shims to the clamp ring to obtain a clearance of max.
0.10
mm (0.004") between the clamp ring and the
gear housing. Push the clamp ring into its position by
hand and use a feeler gauge and measure the clear-
ance all around.
9.
Install the locking ring (1) and the recessed washer
(
2) along with shims and install the O-ring (3) in the
groove of the recessed washer. Use grease to get at-
tachment.
43
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok