Repair instructions
Final assembly
884830
1
1.
Dismantle pinion and gear and clean parts from
3. Install the O-rings (1) in the propeller bearing hous-
ing. Coat the contact surfaces and the screws with
sealing compound, Volvo Penta part no. 1161099-5 or
®
Permatex no. 3. Install the propeller bearing housing
in the gear housing and tighten the 2 Allen-head
screws.
marking dye and then assemble with the calculated
shims. Then install the spacer ring, the locking ring
and the nut on the vertical shaft. Tighten the nut and
lock with the locking washer. Use special tool
884830
as a counter hold.
NOTE! Turn the vertical shaft somewhat to allow the
gears to engage. Tightening torque 40 Nm
(29.5
lb.ft.).
1
2.
(118
(
Tighten the pinion nut with a torque of 160 Nm
lb.ft.). Then lock the nut with the locking washer
1). Use special tool 884830 applied at the splines
shaft end as a counter hold.
98
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok