Repair instructions
7.
Remove the left hand thread nut on the vertical
shaft. Use special tool 884830 and the spline shaft as
a counter-hold while removing the nut.
5.
Remove the 4 screws holding the gear housing cov-
er.
1
2
8.
Lift out the upper bearing assembly along with the
sliding sleeve and the spring.
1
2
6.
Remove the cover.
NOTE! The front right hand screw (1) is a hollow
screw with an O-ring. Do not damage or lose the
shims (2) for the cover.
9.
Lift out the upper gear housing from the special
tool. Disassemble the bearing assembly and shaft by
lifting the shaft enough to remove the split locking ring
(
1), then the thrust washer (2).
NOTE! Do not scratch the sliding sleeve or the gear
cups while removing them.
47
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok