Repair instructions
32.
Apply marking dye on the convex side of the aft
884806
gear. Place the calculated shims for the intermediate
bearing and the intermediate bearing on the inner pro-
peller shaft. Install special tool 885197 onto the
threads until the tool bottoms.
29.
Press the needle bearing into the propeller shaft
with the text on the bearing turned facing the tool. Use
special tool 884806. Press the tool until it bottoms.
884798
NOTE! Do not install the seal rings, wait until the gear
tooth clearance and contact pattern are checked.
33.
Install special tool 884798 on the propeller shaft
with the washer and nut. Using a 30 mm wrench, tight-
en the nut until the intermediate bearing bottoms. Use
special tool 884830 or 3850598 and a wrench as a
counter hold on the vertical shaft. After the intermedi-
ate bearing is pressed on completely, remove the
special tools from the propeller shaft.
30.
Press the roller bearing onto the propeller shaft.
Use special tool 884801.
34.
Coat the convex side of the aft gear with marking
dye. Insert the gear assembly onto the inner propel-
ler shaft.
31.
Press the inner needle bearing race onto the pro-
peller shaft. Use special tool 884801.
113
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok