Repair instructions
1
7.
Install the shift linkage rod, washer and cotter pin.
5.
Install the O-ring (1) on the upper gear.
WARNING! Always use a new cotter pin. Never
reuse a cotter pin that has been removed.
2
1
885009
3
885008
6.
Install the upper gear housing on the intermediate
housing. Use new Allen bolts (1, 2 pcs), washers (2,
pcs) and nyloc nuts (3). Many drives do not have
2
washers under the bolt heads. When overhauling
however, washers shall always be fitted. This applies
to all drives. Apply some grease to the Allen bolt and
stud threads, and to the contact faces of the nuts and
washers. Tighten the screws and nuts in diagonal
sequence and evenly all around and with a torque of
38
Nm (28 lb.ft). Use tool 885008 and 885009.
123
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok