Repair instructions
Shimming the lower gear to the
intermediate housing
884168
A
3.
Press the outer race of the vertical shaft bearing
with the calculated shims into the intermediate hous-
ing. Use special tool 884168.
1.
Place the bearing race on the bearing and hold in
position. Using a depth gauge, measure the bearing
height above the lower unit parting plane “A”.
B
2.
Using the depth gauge, measure the measurement
4. Insert the oil strainer (5) into the lower gear hous-
ing. Check that the spacer sleeve (4) is provided with
an O-ring. Use new O-rings (3) and (4). Install the
spline sleeve (1) on the vertical shaft with the groove
in the up position. Coat the contact surfaces with a
thin coating of Volvo Penta part no. 1141570-0 seal-
ant.
“
B” in the intermediate housing .
Subtract measurement “A” from measurement “B”.
B – A = positive result ( clearance dimension)
B – A = negative result (preload)
Tolerances: Max. allowed clearance dimension
0.05
mm (0.002”)
Max. allowed preload 0.02 mm (0.0008”).
For calculation of shims see point 37 on page 114.
120
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok