Repair instructions
10.
Install the shims and the 2 new O-rings on the
12. Apply Volvo Penta part no. 1161099-5, Permatex
®
double bearing box.
no. 3 on the surfaces between the clamp ring and gear
housing.
Install the double bearing box along with the universal
joint in the gear housing. The guide pin in the double
bearing box should be turned downwards. Lock the
screws with thread locking compound, Volvo Penta
part no. 1161053-2 and tighten them with a torque of
35
Nm (25.8 lb.ft.).
If necessary, recondition the universal joint. See
chapter Reconditioning the universal joint, pages
62–63.
11.
Install the clamp ring and the double bearing box
on the universal joint.
NOTE! The guide pin (1) must fit the groove in the
clamp ring. Install the washer (2) and the screw (3).
At final assembly always use a new screw! Coat the
screw with Volvo Penta part no. 1161053-2, locking
fluid and tighten with a torque of 75 Nm (55 lb.ft.).
13.
Install shims under the cover to obtain a clearance
of max 0.1 mm (0.004") between the cover and the
gear housing. Install the cover and push it into its po-
sition and measure the clearance with a feeler gauge
all around.
44
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok