Repair instructions
1
884266
1
3.
Grease abundantly the outer race (1) with grease
5. Install the spacer pad (1) on the ball bearing and
press on the roller bearing. Use special tool 884266.
and insert the 27 needles, well cleaned, into the ring
letting the grease hold them. Insert special tool 84385
in the bearing and insert the bearing from underneath
into the gear housing. Then install the special tool
884241
from above and pull the bearing into its seat in
the gear housing.
3
2
1
The vertical shaft
884266
1
6a. Models 280 and 290 of earlier manufacture and
model SP: Install the spacer ring (1), the locking
washer (2) and the round nut (3) on the vertical shaft.
Tighten the nut.
NOTE! Don’t lock the nut with the washer just yet.
4.
Press on the ball bearing on the vertical shaft. Use
special tool 884266.
NOTE! Install the ball bearing according to figure in a
way that the balls (1) become visible.
91
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok