Repair instructions
Installing the sterndrive
Models 280 and 285
There are 2 types of exhaust bellows. One type with
an exhaust valve and one without. The exhaust bel-
lows with an exhaust valve installed should be used
on sterndrives not having a rubber exhaust flap in-
stalled on the exhaust outlet in the cavitation plate.
Otherwise exhaust bellows without exhaust valve
should be installed.
2. Check to make sure that the hole in the suspension
yoke for the push rod is chamfered. The chamfer
should be 1 mm × 45° (0.004" × 45°) to prevent the
thrust washer of the lifting device to deform the edg-
es of the hole when tilting the sterndrive. In case the
thrust rod is jamming in the hole, the sterndrive will
kick up when put in reverse. Should this happen,
push down the push rod and adjust the chamfer.
IMPORTANT! When using an exhaust bellows
with built-in flaps, make sure that the flaps are
opening/closing horizontally. Furthermore
check that the bellows is installed with the
drainage hole pointing downwards.
1.
Install new rubber bellows for the through-hull ex-
haust (1) and the universal joint (2). Use special tool
. Connect the cooling water hose (3) between
3. Put the sterndrive in front of the transom shield.
Block it from underneath to align it heightwise with the
transom shield. As an alternative the special tool
884936
the transom shield and the sterndrive.
884521
sterndrive.
can be used. Insert the shift cable (1) in the
NOTE! The cooling water hose is marked ‘engine’ at
the end to be connected to the transom shield.
Check to make sure that the hose clamps are well
tightened to avoid water leaking into the boat. Use
the flexible screwdriver 884573 to tighten the clamps.
125
Categories | Volvo Penta Manuals |
---|---|
Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5) Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews.
Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok