Transom shield
Trim cylinders, all models
Part no.
940194
6.
bushing (late models) or plastic plug (early models)
was removed.
Install a grease nipple where the ground terminal
8. Use a grease gun and inject grease into the grease
nipple. The dowel pin will then be pushed out and the
trim cylinder can be removed.
Use grease nipple, Volvo Penta part no. 940194.
884978
1
2
7.
pin. Key width 10 mm.
Remove the locking bolt for the trim cylinder dowel
9. If the dowel pin will not come out by using a grease
gun, special tool 884978 should be used as follows:
Remove the grease fitting.
Fill the tool with grease.
Screw the tool into the transom shield and carefully
tighten.
Unscrew the locking trim cylinder pin locking bolt (1)
approx. 10 mm (¼”).
Hit the tool piston (2) with a hammer so that the trim
cylinder pin is forced against the locking bolt.
Unscrew the locking bolt completely. Force the pin the
rest of the way out of the hole.
143
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok