Repair instructions
Models 290, SP and DP
1.
Install the exhaust bellows on the transom shield.
3. Remove the locking screw and remove the sus-
Turn the hose clamp so that the tightening screw
ends up at two o’clock with the head pointing down-
wards.
pension pin. Grease the suspension pins with Volvo
Penta low temperature grease 1161417-9 and install in
the transom shield flush with the interior face to the
transom shield. Grease the locking bolt with Volvo
Penta low temperature grease 1161417-9. Put the
locking bolts aside for installation later.
NOTE! Turn the drainage hole in the bellows facing
downwards.
885146
2.
Hang on the hose clamp and install the universal
4. Install the yoke 885146 in the transom shield.
joint bellows. Locate the tightening screw at
3
o’clock.
132
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok