Repair instructions
1
2
3
22.
Install the eccentric piston (1) in the housing. Do
not damage the seal! Push in the locating pin (2).
Align the hole with the housing. Lock it in place with a
new spring pin (3).
24.
Install the shift mechanism in the gear housing in
a way that the screw (1) is displaced towards star-
board.
NOTE! Make sure that the sliding shoe (2) is turned
to a position as indicated in the picture. The shift
mechanism will not function if the sliding shoe is
turned in the opposite direction.
1
2
3
23.
Install a new O-ring (3) and insert the spring (2)
and the sliding shoe (1). Coat the contact surface with
Volvo Penta part no. 1141570-0 sealant.
25.
Set the shift mechanism in a position between
forward and neutral or between reverse and neutral.
(The pin (1) shall rest on one of the ‘cams’). Install the
shift mechanism in the sterndrive.
70
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok