Repair instructions
11a.
Sterndrives model 280 and 290 of earlier man-
ufacture:
Install the thick spacer ring (1), the locking washer (2)
and the round nut (3) on the vertical shaft.
NOTE! Install the nut with the even side facing up-
wards. Tighten the nut but don’t lock it with the wash-
er. Use a hook spanner wrench.
12.
Find the “H”-marking on the parting plane of the
lower gear housing. The “H”-stamping in this instance
is 37. Remember, the stamping is in hundreds of mil-
limeters. The nominal “H”-measurement is 277. Add
the “H”-stamping to the nominal dimension of 277. The
sum will be 277.37 mm.
Add:
“
“
“
H”-Nominal
277.00 mm
+00.37 mm
277.37 mm
H”-Stamping
H”-Measurement
11b.
Sterndrives model 280 and 290 of later manu-
facture and sterndrives model DP:
Install the thick spacer ring and tighten the plastic in-
sert locknut. Use a hook spanner wrench.
13.
Find the marking on the pinion gear. In this in-
stance the pinion etching is -5. Remember, the etch-
ing is in hundreds of millimeters. This etching is -0.05
mm. The nominal measurement of the pinion gear is
60.00
mm. Subtract the pinion gear etching from the
nominal measurement for a difference of 59.95 mm.
108
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok