Repair instructions
1
23.
Remove the inner needle bearing and seals using
special tools 884803 and 884143. Install special tool
884789
to protect the propeller shaft threads.
NOTE! If you only want to replace the seals, it is still
easier to remove the seals along with the bearings.
21.
Install a knife puller on the outer propeller shaft
roller bearing. Using a press, remove the roller bear-
ing.
Propeller shaft bearing box
IMPORTANT! Make sure the sealing surfaces
(
1) of the shaft are not damaged during the proc-
ess!
884797
884832
22.
Install special tool 884832 under the intermediate
bearing outer race. Insert handle 884143 to expand
the bearing tool. Press out the intermediate bearing
outer race from the rear propeller shaft gear.
24. Remove the O-rings from the propeller shaft bear-
ing housing and discard. Using special tool 884797 to
press out the seals and needle bearings.
WARNING! Center the tool carefully. Locate a
pair of wooden blocks underneath the bearing
box to protect the bearing box. Always use new
seals and O-rings during final assembly.
103
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok