Repair instructions
884259
7.
884140
Dismantle the axial bearing race. Use special tools
and 884143. Also replace the O-rings (1).
One at each end of the tube.
5.
Press out the bushing (1). Use special tool 884259.
6.
Should the shift yoke need to be replaced, remove
the cotter pin (1). Then it is possible to pull out the
shaft (2) and the shift yoke (3).
8.
The retaining pawl is dismantled, when necessary,
as follows:
Remove the shaft journals (48). Remove the spring
(
57), the spring (49) and the springs (58).
NOTE! Hold the spring shaft (50). Remove the nuts
(
55) and the spring catches (52) and (54) and the
spacer washers (44) and the retaining pawl (42). Lift
out the bearing (43) and the shaft (53) and the push
rod (45). Wash the parts and check for wear. Re-
place parts if necessary.
74
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok