Repair instructions
15.
Insert the wear washer (1) between the steering
yoke and the intermediate housing and push in the
steering spindle until the collar bottoms.
17.
If the trim cylinder attachment is in need of repair
or in need of being replaced, remove the 2 collar
screws. Use a socket wrench (17 mm) as a counter
hold. Then install the new cylinder attachment.
NOTE! Use the same screws, washers and nuts un-
less they are damaged.
16.
Install the hose connection and the gasket on the
yoke. Coat the surfaces with sealing compound,
Volvo Penta part no. 1161099-5 or Permatex no. 3.
18. Install the shift yoke (3) and push in the shaft (2)
and lock it with the cotter pin (1).
®
NOTE! Install a washer on each side of the cotter
pin!
81
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok