Repair instructions
884168
1
5.
Remove the 6 nuts holding the washer (1) and
7. Press off the gear wheel and the bearing from the
propeller shaft simultaneously. Use special tool
884168.
knock the propeller shaft out of the bearing housing.
Use a copper mallet or its equivalent in order not to
damage the threads.
1
3
3
2
1
2
6.
Fold down the locking washer (1) remove the round
8. Remove the locking ring (1) and the oil deflector (2)
nut (2).
from the gear wheel.
NOTE! In order not to damage the oil deflector dur-
ing the dismantling, apply the bending tool close to
the 2 carrier pins (3). (This is valid for sterndrives of
earlier manufacture). On sterndrives of later manu-
facture the carrier pins have been replaced by a load
pin.
87
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok