Trim system
The instrument, when trimmed down and with a
known transom angle, shows the following figures,
see table below:
Checking the trim figure
4.
1.
Turn the ignition key to the ignition position (the
lights are on).
Transom angle
Instrument indication
10°
11°
12°
13°
14°
15°
- 2
- 3
- 4
- 5
- 6
- 7
2.
Trim down the drive to its bottom position.
NOTE! Push the switch upwards.
5.
If the instrument shows a different figure than that
stated in the table, then action as described below must
be taken.
Adjusting the trim figure
3.
To ensure that the drive rests against the adjusting
rod it should be loaded with approx. 15 kp (33 lb.).
6.
Loosen the trim sender’s fixing bracket (A) and turn
the trim sender housing (B) until the instrument shows
the correct figure according to the table.
Then retighten the fixing bracket for the sender and re-
move the load from the drive.
159
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok