Transom shield
Trim cylinders, all models
Trim
Trim
pump,
earlier
model
pump,
later
model
Trim
pump,
earlier
model
IMPORTANT! The hydraulic pump must be in-
stalled vertically, as reflected by the picture.
16.
Remove the oil filler/indicator plug to check the oil
level. Top up if necessary. Install the sterndrive in the
transom shield. Raise and lower the drive simultane-
ously to facilitate the topping up and to make sure
that the system is properly filled up. The oil level
should be level with the oil filler hole. Use the same oil
quality as for the engine or ATF oil. See below.
18.
Should the low pressure hoses (1) and high pres-
sure hoses (2) need to be disconnected for any rea-
son it is vital that they be reconnected to the correct
hose connection.
Trim
pump,
later
The figures above show how the hoses shall be con-
nected on the inside and outside of the transom
shield.
model
NOTE! The outer low pressure hose (3) is marked
white and the outer high pressure hose (4) is marked
red.
17.
Oil level, hydraulic pump – power trim:
Trim in the drive as far as possible. Check that the oil
level is between the max and min. marks on the
reservoir. Top up if necessary with ATF oil.
NOTE! Early production drives were filled with engine
oil and have that recommendation in the Owner’s
Manual. Late production drives have ATF oil filled.
IMPORTANT! We recommend the use of ATF
oil. Observe strict cleanliness so that dirt is not
drawn in by the oil.
ATF oil and engine oil must never be mixed.
If ATF oil is to be used, the engine oil must first
be drained from the system. If the system has
been drained, fill up with new oil and trim the
drive 6 to 10 times in and out to purge air from
the system. Check the oil level and top up if
necessary.
146
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok