Repair instructions
885143
13.
Pull down the retaining pawl and lift up the stern-
15. Check to make sure that all bellows and hoses
drive sufficiently to allow the installation of special
tool 885143 between the transom shield and the sus-
pension yoke.
have been installed correctly and well tightened.
Tilt the sterndrive and turn it fully both ways and
check simultaneously that the tightening screws of
the bellows do not touch neither the sterndrive, the
transom shield nor the bellows. Adjust if necessary.
Use special tools 885143 and 884573.
Hang the hose clamp on to the cooling water hose and
connect the hose to the hose attachment on the
suspension yoke.
The above picture reflects the correct positioning of
the hose clamps.
IMPORTANT! Turn the hose clamp so that the
tightening screw ends up at two o’clock on the
starboard side. This is important. Should the
hose clamp be installed incorrectly, this can
damage any of the other bellows.
14.
Hang on the hose clamp for the exhaust bellows
16. Center the cylinder attachment holes and the cyl-
inders. Grease the trim cylinder bolts and install
them.
and push it onto the neck of the sterndrive. Turn the
hose clamp into the position indicated by the picture.
See also point 15.
135
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok