Repair instructions
7.
If necessary the retaining pawl is dismantled as fol-
9. Paint the retaining pawl with a thin layer of
lows:
”touch-up paint”. Painting is hard to do when the pawl
is assembled.
Remove the shaft journals (42). Remove the spring
(
43) the spring (40) and the springs (44).
The picture reflects an assembled retaining pawl.
NOTE! Hold the spring shaft (45). Remove the nuts
(
38) and spring catches (34) and (37) and the spacer
washers (36) as well as the retaining pawl (33). Re-
move the bearing (32) and the shaft (35). Clean the
parts and check for wear. Replace parts if necessary.
9991801
884259
Assembly
Oil all moving parts and the screws prior to as-
sembly.
8.
Install the shaft (35, picture above) on one of the
retaining pawls (33) and install the spacer washer (36)
and the spring catch (34). Install one of the nuts (38)
on the shaft. Then place the stop shaft (39) and the
bearing (32) in the retaining pawl half. Then install
the remaining retaining pawl (33) and the spring
catch (37) the spacer sleeve (36) on the shaft (35)
and the bearing (32). Install the second nut (38).
10.
Grease the needle bearing with an universal type
of grease and press it into the center of the yoke. Use
special tools 884259 and 9991801. Turn the bearing
in a way that the tool is pressing against the side
where the material is at the thickest (where the text is
stamped into the material).
NOTE! Tighten the nuts (38) completely. Then ease
off a 1/8 turn to allow the spring catches to move
without adding a play. Then install the locking yoke
(
41) and the shaft journals (42) with the spring (43)
and the washer (46) in the bearing (32). Install the
spring shaft (45) in its location with the assistance of
the springs (44) and install the spring (40) between
the bearing (32) and the stop shaft (39).
79
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok