Repair instructions
1
9.
Install new O-rings (1) on the bearing box. Coat the
12. Install the zinc ring on the lower gear housing.
Check to make sure that the contact surfaces are
clean and there is a good electrical contact.
entire sealing surface and O-rings with Volvo Penta
part no. 1141570-0 sealant. Install the bearing box in
the gear housing.
An ohmmeter may be used to ensure there is little or
no resistance between the zinc ring and the lower unit
housing.
For more detailed information about Electrochemical
Corrosion, what causes it and how to prevent it, con-
sult publication 7733534-7, Marine Electrical Sys-
tems available from Volvo Penta.
10.
Tighten the bolts to 40 Nm (30 lb.ft.).
11.
Remove the seal protector (1) when the bearing
box has been installed and tightened. Clean off any
excess sealing compound.
119
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok