Repair instructions
Assembly
Oil all moving parts and the screws prior to as-
sembly.
10.
Paint the retaining pawl with a thin layer of
‘touch-up paint’. Painting is hard to do when the pawl
is assembled.
The picture reflects an assembled retaining pawl.
9991801
884259
9.
Install the shaft (53) on one of the retaining pawls
(
(
42) and the spacer washer (44) and the spring catch
52). Install one of the nuts (55) on the shaft. Then
place the push rod (45) on the stop shaft (56) and in-
sert the bearing (43) in the retaining pawl half. Then
install the remaining retaining pawl (42) and the
spring catches (54) along with the spacer washer
11. Grease the needle bearing (1) with an universal
type of grease and press it into the center of the yoke.
Use special tool 884259 and 9991801. Turn the
bearing in a way that the tool is pressing against the
side where the material is at the thickest, (where the
text is stamped into the material).
(
44) on the shaft (53) and the bearing (43). Install the
remaining nut (55).
NOTE! Tighten the nuts (55) completely. Then ease
them off approx. / turn in order to make the spring
1
8
catches movable without adding a play. Then install
the locking yoke (47) and the shaft journals (48)
along with the spring (57) and the washer (51) in the
bearing (43). Install the spring shaft (50) with the as-
sistance of the springs (58) and install the spring (49)
between the bearing (43) and the stop shaft (56).
75
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok