Repair instructions
Assembly
Oil all moving parts and the screws prior to as-
sembly.
884316
1
17.
Should the needle bearing of the propeller shaft be
damaged, use special tool 884316 to remove it. In-
sert the puller into the needle bearing in a way that
the barbs of the puller end up at the backside of the
needles. Then tighten the puller forcing the barbs
apart and pull out the bearing.
1.
and press them home in the propeller bearing housing.
Fill up with grease between the two sealing rings (1)
Use special tools 884283 and 9991801.
NOTE! Turn the sealing rings correctly. They are to
seal against the oil in the gear housing as well as
against water.
9991801
884283
18.
Remove the bearing race on the propeller shaft by
cracking it. Clean all parts and check them for wear.
Replace parts if necessary.
NOTE! The gear wheels are sold in matched pairs in
order to obtain the correct contact pattern.
2.
Install the needle bearings for the propeller shaft.
The side of the needle bearing carrying the descrip-
tion must be turned facing aft. Use special tools
884283
and 9991801.
90
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok