Repair instructions
10.
Install special tool 885197 on the inner propeller
shaft.
7.
Remove the two Allen-head screws from the propel-
ler bearing housing. Key width: /8”.
3
884802
884789
884161
11.
Install special tool 884802 over the inner propeller
shaft. Add the washer and nut from tool 885197. The
slot in the end of the tool should face the pinion gear.
Tighten the nut until the shaft is extracted from the
forward gear. Use a 30 mm wrench.
8.
Install special tool 884789 on the outer propeller
shaft. Using special tool 884161 with a slide ham-
mer, remove the outer propeller shaft and bearing
housing.
1
885143
9.
housing. Discard the O-rings.
Remove the 2 O-rings (1) from the propeller shaft
12. Brace special tool 884830 in a vise and place the
lower unit upside down in the tool.
100
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok