Repair instructions
Disassembly, models
280,
285 and 290
3.
Remove the 7 screws holding the lower gear hous-
ing to the intermediate housing. Use a rubber mallet
and knock the housings carefully apart. Lift off the
splines sleeve (1).
1.
Remove the shift rod (1) from the shift plate (2). Re-
NOTE! On sterndrives of later manufacture the 4 big-
ger-sized screws are installed with stainless steel
washers. Take care of these washers.
move the screws (3) and the nuts (4) holding the in-
termediate housing to the upper housing. Use a rub-
ber mallet to knock the housings apart. Knock care-
fully.
2.
Keep check on the number of shims (1) between
the different housings and for all the gear sets in case
neither the gears, housing nor the bearings need to
be replaced. In this case the same shim thickness is
to be used.
884264
884830
4.
884264
Install the upper gear housing in the special tool
. This tool, of later manufacture, carries the
part number 884830.
30
| Categories | Volvo Penta Manuals |
|---|---|
| Tags | Volvo Penta 280, Volvo Penta 280-DP, Volvo Penta 285, Volvo Penta 290, Volvo Penta 290-DP, Volvo Penta DP-A, Volvo Penta DP-B, Volvo Penta DP-C, Volvo Penta SP-A, Volvo Penta SP-C |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(9 votes, average: 4.22 out of 5)
Marine readers have rated Volvo Penta 280 285 290 DP SP A B C Workshop Manual 4.2 out of 5.0 based on 9 product reviews. Problem Winther noise when turne
not pulling water so hope I find the info
Kinda a premature review, at this point I am asked to review the manual before ever seeing it?
Great step by step information.
thank you
needed it bad
ok