SERVICE MANUAL NUMBER 23
VELVET DRIVE 5000A DOWN ANGLE TRANSMISSION
CAUTION
Remote control and shift cable must position transmission shift lever exactly as
shown, or transmission failure may occur. Do not remove poppet ball or spring.
a
e
c
b
d
73248
a - Transmission Shift Lever
b - Poppet Ball Must Be Centered in This Detent Hole when Left-Hand Propeller
Shaft Rotation Is Desired
c - Poppet Ball Must Be Centered in This Detent Hole when Right-Hand Propeller
Shaft Rotation Is Desired
d - Poppet Ball Must Be Centered in This Detent Hole for Neutral Position
e - Install Shift Lever Stud in This Hole when Using Quicksilver Shift Cables
7.
Place remote control shift lever in opposite gear position and again check transmission
shift lever position. Lever must be positioned as shown by (c).
8.
If transmission shift lever will not position properly in one gear or both gears, recheck
shift cable adjustment and travel as previously instructed in “a”-“h.” If proper positioning
is still not obtained, remote control does not provide sufficient shift cable travel and must
be repaired or replaced.
9.
Install nut and washer to cable end guide stud. Tighten until snug, then back off one full
turn.
Index
90-861326--1
MARCH 1999
Page 8B-13
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 454 CID, Mercury MerCruiser 502 CID |
| Model Year | 1998, 1999, 2000, 2001 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Marine readers have rated Mercury MerCruiser GM V8 GM V8 454 CID 7.4L and 502 cid 8.2L Marine Engines Service Manual Number 23 5.0 out of 5.0 based on 1 product reviews. Just need the manual. Wrote review. Can't technically review what I haven't seen yet...