SERVICE MANUAL NUMBER 23
SEAWATER COOLED MODELS
Testing
1.
2.
3.
Clean thermostat in soap and water to remove any deposits or debris.
Inspect thermostat for corrosion or other visible damage.
If thermostat is suspected of producing insufficient engine temperature, check thermo-
stat for leakage by holding it up to a lighted background. Light leakage around the ther-
mostat valve indicates that thermostat is not closing completely and should be replaced.
(A small amount of leakage at one or two points around the valve perimeter is accept-
able.)
a
72717
a - Check For Light Leakage Around Perimeter Of Valve
4.
Check opening and closing temperature of thermostat (using a tester similar to the one
shown) as follows:
a. Fill tester to within 1 in. (25 mm) of top with tap water. Do not use distilled water.
b. Open thermostat valve and insert nylon string. Position thermostat on string so that
it will be just below water level when suspended, then allow valve to close. Suspend
thermostat in water.
c. Place thermometer in container and position so that bottom of thermometer is even
with bottom of thermostat. Do not allow thermometer to touch container.
a
b
c
72675
a - Thermometer
b - Nylon String
c - Thermostat
90-861326--1
MARCH 1999
Page 6A-25
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 454 CID, Mercury MerCruiser 502 CID |
| Model Year | 1998, 1999, 2000, 2001 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Marine readers have rated Mercury MerCruiser GM V8 GM V8 454 CID 7.4L and 502 cid 8.2L Marine Engines Service Manual Number 23 5.0 out of 5.0 based on 1 product reviews. Just need the manual. Wrote review. Can't technically review what I haven't seen yet...