SERVICE MANUAL NUMBER 23
MCM MODELS - BRAVO AND BLACKHAWK DRIVES
CAUTION
Center lifting eye (located on top of thermostat housing) is used for engine
alignment only. DO NOT use to lift entire engine.
CAUTION
Engine MUSTbeliftedwithaliftingarmordamagetoenginecomponentswilloccur.
DO NOT allow lifting sling to hook or compress engine components or damage will
occur.
6.
Attach a suitable sling to lifting eyes on engine and adjust so that engine is level when
suspended. (Refer to “Removal” section for location of lifting eyes.)
7.
8.
Lift engine into position (in boat), using an overhead hoist.
Align rear engine mounts with inner transom plate mounts while simultaneously aligning
exhaust tubes with exhaust pipe hoses (bellows).
IMPORTANT: Engine attaching hardware must be installed in sequence shown.
Install both rear engine mounting bolts and hardware as shown. Torque to 35-40 lb-ft
9.
(47-54
Nm).
a
c
b
d
e
g
h
f
72535
Typical Installation
a - Bolt, Rear Engine Mounting
b - Washer, Large Steel
c - Metal Spacer
d - Rear Engine Mount
e - Double Wound Lockwasher
f - Fiber Washer
g - Inner Transom Plate Mounts
h - Locknut (Hidden In This View)
CAUTION
When lowering engine into position DO NOT set engine on shift cable. Shift cable
outer casing can be crushed causing difficult or improper shifting.
Index
90-861326--1
MARCH 1999
Page 2A-5
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 454 CID, Mercury MerCruiser 502 CID |
| Model Year | 1998, 1999, 2000, 2001 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Marine readers have rated Mercury MerCruiser GM V8 GM V8 454 CID 7.4L and 502 cid 8.2L Marine Engines Service Manual Number 23 5.0 out of 5.0 based on 1 product reviews. Just need the manual. Wrote review. Can't technically review what I haven't seen yet...