DRIVE SHAFT / PROPELLER SHAFT MODELS
SERVICE MANUAL NUMBER 23
7.
Install input shaft, then install snap ring. Wipe up excessive Loctite.
IMPORTANT: Do not let Loctite get into ball bearing.
8.
Fill bearing area with Quicksilver U-Joint and Gimbal Bearing Grease through grease
fitting.
9.
Apply Quicksilver Engine Coupler Spline Grease to splines of input shaft before install-
ing drive unit.
a
b
c
e
f
g h
i
d
75281
7.4L
MPI Version
a - Snap Ring - Input Shaft
b - Snap Ring - Ball Bearing
c - Ball Bearing
d - Bearing Support
e - Grease Fitting
f - Oil Seal
g - Grease Fitting
h - Input Shaft
i - Plug - Input Shaft
Installation
1.
Install bearing support assembly (tailstock) on transom plate using hardware as shown.
Tighten bolts until snug. DO NOT TORQUE BOLTS AT THIS TIME.
IMPORTANT: The spherical washers MUST BE positioned so that the rounded side
of the washers are toward the bearing support assembly as shown.
g
h
a
b
dc
e
i
75279
a - Bolts 1/2-20 x 4 In. (102 mm) Long
b - Steel Washer (Flat)
c - Spherical Washer (Rounded On One Side)
d - Bearing Support
e - Spherical Washer (Rounded On One Side)
f - Nut 1/2-20
g - Transom Plate
h - Bearing Support (Tailstock)
Index
Page 8F-12
90-861326--1 MARCH 1999
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 454 CID, Mercury MerCruiser 502 CID |
| Model Year | 1998, 1999, 2000, 2001 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Marine readers have rated Mercury MerCruiser GM V8 GM V8 454 CID 7.4L and 502 cid 8.2L Marine Engines Service Manual Number 23 5.0 out of 5.0 based on 1 product reviews. Just need the manual. Wrote review. Can't technically review what I haven't seen yet...