DRIVE SHAFT / PROPELLER SHAFT MODELS
SERVICE MANUAL NUMBER 23
5.
Torque bolts to 35-54 lb. ft. (47-73 N·m) as shown.
71099
6.
7.
Refer to appropriate Sterndrive Service Manual and install drive unit.
Refer to SECTION 2 “Removal and Installation - Engine Installation/Alignment,” if
engine was removed.
Propeller Shaft (MIE Inboard Models)
NOTICE to INSTALLER
The following information can be used as a guide for determining vibration prob-
lems on boats powered by inboard engines (MIE models). For installation, align-
ment and repairs to shafts, struts, shaft logs and rudders, refer to boat manufactur-
er’s service manual. If boat is equipped with V-drive, or a remote mounted V-drive,
refer to SECTION 8B or boat manufacturer’s service manual for all servicing and
troubleshooting. For MIE engine installation and alignment, refer to SECTIONS 2E
and 2F.
Checks Made with Boat In Water
1.
2.
Disconnect propeller shaft coupling from transmission coupling.
Check fit of coupling “a” or “b” to propeller shaft.
a. Straight Bore Type:
(1.)
(2.)
Loosen setscrews.
Try to move coupling by hand. The bore of the coupling should be a semi-press
fit to shaft.
(3.)
(4.)
Check shaft for wear. If worn, replacement of shaft may be necessary.
If shaft is not worn, try another coupling.
Index
Page 8F-14
90-861326--1 MARCH 1999
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 454 CID, Mercury MerCruiser 502 CID |
| Model Year | 1998, 1999, 2000, 2001 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Marine readers have rated Mercury MerCruiser GM V8 GM V8 454 CID 7.4L and 502 cid 8.2L Marine Engines Service Manual Number 23 5.0 out of 5.0 based on 1 product reviews. Just need the manual. Wrote review. Can't technically review what I haven't seen yet...