SERVICE MANUAL NUMBER 23
454 CID (7.4L) / 502 CID (8.2L)
5.
Slip outer surface of a new top and second compression ring into respective piston ring
groove and roll ring entirely around the groove to make sure that ring is free as shown.
If binding occurs at any point, determine cause. If caused by ring groove, remove by
dressing with a fine cut file. If binding is caused by a distorted ring, recheck with another
ring.
72366
6.
Proper clearance of piston ring in its piston ring groove is very important to provide
proper ring action and reduce wear. Therefore, when fitting new rings, clearances
between ring and groove surfaces should be measured. See “Specifications.”
72367
PISTON PINS
1.
2.
Piston pin clearance is designed to maintain adequate clearance under all engine
operating conditions. Because of this, piston and piston pin are a matched set and not
serviced separately.
Inspect piston pin bores and piston pins for wear. Piston pin bores and piston pins must
be free of varnish and scuffing when measured. Measure piston pin with a micrometer
and piston pin bore with a dial bore gauge or inside micrometer. If clearance is in excess
of the .001 in. (0.025 mm) wear limit, replace piston and piston pin assembly.
Index
90-861326--1 MARCH 1999
Page 3A-69
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 454 CID, Mercury MerCruiser 502 CID |
| Model Year | 1998, 1999, 2000, 2001 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Marine readers have rated Mercury MerCruiser GM V8 GM V8 454 CID 7.4L and 502 cid 8.2L Marine Engines Service Manual Number 23 5.0 out of 5.0 based on 1 product reviews. Just need the manual. Wrote review. Can't technically review what I haven't seen yet...