DRIVE SHAFT / PROPELLER SHAFT MODELS
SERVICE MANUAL NUMBER 23
Bearing Support Repair (MCM Sterndrive Models)
Removal
IMPORTANT: It is not necessary to remove the engine to service the drive shaft and/or
bearing support.
CAUTION
If bearing support is removed, you must remove the sterndrive unit so you can
properly align drive unit U-joint centerline with extension drive shaft U-joint center-
line. Lack of alignment will cause a severe vibration problem.
1.
2.
3.
Remove drive shaft as previously outlined.
Remove sterndrive unit (refer to appropriate Stern Drive Service Manual).
Remove bearing support and retain hardware.
a
b
c
d
c
75279
e
a - Bolt, Bearing Support (2)
b - Flat Washer (2)
c - Spherical Washer (4)
d - Bearing Support (Tailstock)
e - Nut (2)
Disassembly
1.
2.
3.
4.
5.
6.
Remove snap ring, then remove input shaft.
Remove larger snap ring.
Using Quicksilver Slide Hammer Puller, remove ball bearing.
Remove oil seal.
If required, remove plug from end of input shaft.
Clean and inspect all parts.
Index
Page 8F-10
90-861326--1 MARCH 1999
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 454 CID, Mercury MerCruiser 502 CID |
| Model Year | 1998, 1999, 2000, 2001 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Marine readers have rated Mercury MerCruiser GM V8 GM V8 454 CID 7.4L and 502 cid 8.2L Marine Engines Service Manual Number 23 5.0 out of 5.0 based on 1 product reviews. Just need the manual. Wrote review. Can't technically review what I haven't seen yet...