SERVICE MANUAL NUMBER 23
CHARGING SYSTEM
Circuitry Test
Perform the following tests, using a 0-20 volt DC voltmeter, to check that all of the circuits
between the alternator and the other components within the alternator system are in good
condition.
OUTPUT CIRCUIT
1.
Connect positive (+) voltmeter lead to alternator output terminal and negative (–) lead
to a ground terminal on alternator.
2.
Wiggle engine wiring harness while observing voltmeter. Meter should indicate approxi-
mate battery voltage and should not vary. If no reading is obtained, or if reading varies,
check alternator output circuit for loose or dirty connections or damaged wiring.
d
a
e
c
72784
b
a - Output Wire - ORANGE
b - Excitation Wire - PURPLE
c - Sensing Wire - RED/PURPLE
d - Voltmeter (0-20 Volts)
e - Ground
EXCITATION CIRCUIT
1.
2.
3.
Connect positive (+) voltmeter lead to tie strap terminal on alternator and negative (–)
lead to a ground terminal on alternator (Test 1).
Turn ignition switch to ON position and note voltmeter reading. Reading should be 1.3
to 2.5 volts.
If no reading is obtained, an opening exists in alternator excitation lead or in excitation
circuit of regulator. Unplug PURPLE lead from regulator. Connect positive voltmeter
lead to PURPLE lead and negative voltmeter leads to ground (Test 2). If voltmeter now
indicates approximate battery voltage, voltage regulator is defective and must be
replaced. If no voltage is indicated, check excitation circuit for loose or dirty connections
or damaged wiring.
4.
If reading is between .75 and 1.1 volts, rotor field circuit probably is shorted or grounded.
Disassemble alternator and test rotor as outlined under “Alternator Repair,” following.
90-861326--1
MARCH 1999
Page 4C-9
Product Specification
Categories | Mercury MerCruiser Manuals |
---|---|
Tags | Mercury MerCruiser 454 CID, Mercury MerCruiser 502 CID |
Model Year | 1998, 1999, 2000, 2001 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
Just need the manual. Wrote review. Can't technically review what I haven't seen yet...