SERVICE MANUAL NUMBER 23
GENERAL SYSTEM DIAGNOSTICS
Injector Balance Test
Test Procedure
(Refer to the following figure for test set-up.)
The injector balance tester is a tool used to turn the injector ON for a precise amount of time,
thus spraying a measured amount of fuel into the manifold. This causes a drop in fuel rail
pressure that we can record and compare between each injector. All injectors should have
the same amount of pressure drop. Any injector with a pressure drop that is 1.5 PSI (or
more) greater or less than the average drop of the other injectors should be considered
faulty and replaced. Injector testers are available for various manufacturers. For 454 and
502
200-400
engines: the tester must be capable of selecting an injector pulse width in the range of
milliseconds (m sec). The recommended starting point for these engines is approx-
imately 300 m sec. In any case a pulse width that drops the fuel rail pressure to half the nor-
mal operating pressure, should be used.
STEP 1
Engine cool down period (ten minutes) is necessary to avoid irregular readings due to “hot
soak” fuel boiling. Relieve fuel pressure in the fuel rail as outlined in “Fuel Pressure Relief
Procedure” in “Repair Procedures.” Remove plenum as outlined in “Repair Procedures.”
With ignition OFF, connect fuel pressure gauge to fuel pressure tap.
Disconnect harness connectors at all injectors, and connect injector tester to one injector.
Use adaptor harness furnished with injector tester to energize injectors. Follow manufactur-
er’s instructions for use of adaptor harness. Ignition must be OFF at least ten seconds to
complete ECM shutdown cycle. Fuel pump should run about two seconds after ignition is
turned ON.
At this point, insert clear tubing attached to vent valve into a suitable container and bleed
air from gauge and hose to ensure accurate gauge operation. Repeat this step until all air
is bled from gauge.
STEP 2
STEP 3
Turn ignition OFF for ten seconds and then ON again several times to get fuel pressure to
its maximum. Record this initial pressure reading. Energize tester one time and note pres-
sure drop at its lowest point. (Disregard any slight pressure increase after drop hits low
point.) By subtracting this second pressure reading from the initial pressure, we have the
actual amount of injector pressure drop.
Repeat Step 2 on each injector and compare the amount of drop. Usually, good injectors
will have virtually the same drop. Retest any injector that has a pressure difference of 1.5
PSI (10 kPa), either more or less than the average of the other injectors on the engine. Re-
place any injector that also fails the retest. If the pressure drop of all injectors is within 1.5
PSI (10 kPa) of this average, the injectors appear to be flowing properly. Reconnect them
and review “Troubleshooting.”
Index
90-861326--1
MARCH 1999
Page 5E-49
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 454 CID, Mercury MerCruiser 502 CID |
| Model Year | 1998, 1999, 2000, 2001 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Marine readers have rated Mercury MerCruiser GM V8 GM V8 454 CID 7.4L and 502 cid 8.2L Marine Engines Service Manual Number 23 5.0 out of 5.0 based on 1 product reviews. Just need the manual. Wrote review. Can't technically review what I haven't seen yet...