TROUBLE CODE DIAGNOSTICS - 7.4L MPI
SERVICE MANUAL NUMBER 23
Code 23 (1 of 3): Intake Air Temperature (IAT) Sensor Circuit (Non-Scan) Low
Temperature Indicated
a
c
B
A
d
b
a - Intake Air Temperature Sensor
b - To TP Sensor
c - IAT Sensor Signal
d - Sensor Ground
CIRCUIT DESCRIPTION:
The Intake Air Temperature (IAT) sensor uses a thermistor to control the signal voltage to
the ECM. The ECM applies 5 volts on CKT 472 to the sensor. When the intake air is cold,
the sensor (thermistor) resistance is high. As the intake air warms up, the sensor resistance
becomes less. see intake air temperature sensor chart under “Diagnostic Aids”. At normal
operating temperature 160°F-180°F (71°C-82°C), the voltage will measure about 1.5-2.0
volts.
DIAGNOSTIC AIDS:
Check for the following conditions:
•
Poor connection at ECM. Inspect harness connectors for backed out terminals,
improper mating, broken locks, improperly formed or damaged terminals, and poor ter-
minal to wire connection.
•
Damaged harness. Inspect the wiring harness for damage. If the harness appears to be
OK, observe the IAT display on the scan tool while moving connectors and wiring har-
nesses related to the IAT sensor. A change in the IAT display will indicate the location of
the fault.
•
If DTC 21 is also set, check for open ground CKT 813.
After repairs, clear DTC’s following “Clearing Trouble Codes” procedure at the front of this
section. Failure to do so may result in DTC’s not properly being cleared.
IMPORTANT: If replacing the ECT, tighten hand tight plus 2-1/2 turns maximum.
Page 5G-14
90-861326--1 MARCH 1999
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 454 CID, Mercury MerCruiser 502 CID |
| Model Year | 1998, 1999, 2000, 2001 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Marine readers have rated Mercury MerCruiser GM V8 GM V8 454 CID 7.4L and 502 cid 8.2L Marine Engines Service Manual Number 23 5.0 out of 5.0 based on 1 product reviews. Just need the manual. Wrote review. Can't technically review what I haven't seen yet...