CHARGING SYSTEM
SERVICE MANUAL NUMBER 23
Component Testing
ROTOR
1.
Test rotor field circuit for opens, shorts or high resistance (Test 1), using an ohmmeter
(set on R x1 scale), as follows:
a
b
72831
Testing Rotor Field Circuit
a - Test 1
b - Test 2
a. Connect one ohmmeter lead to each slip ring.
b. Ohmmeter reading should be 4.2 to 5.5 ohms with rotor at room temperature
°F (21-26°C).
70-80
c. If reading is high or infinite (no meter movement), high resistance or an open exists
in the field circuit. Check for poor connections between field winding leads and slip
ring terminals. If cause for open or high resistance cannot be found, connect ohm-
meter directly to slip ring terminals. If correct reading is now obtained, or if reading
is still high or infinite, replace complete rotor assembly.
d. If reading is low, a short exists in the field circuit. Inspect slip rings to be sure that
they are not bent and touching outer slip ring. Also, be sure that excess solder is not
shorting terminals to aft slip ring. If cause for short cannot be found, unsolder field
winding leads from slip ring terminals and connect ohmmeter directly to leads. If
correct reading is now obtained, or if reading is still low, slip rings and rotor field
windings are shorted, and complete rotor assembly must be replaced.
d
b
c
a
73112
a - Field Winding Leads
b - Slip Rings
c - Rotor Shaft
d - Pole Pieces
Page 4C-20
90-861326--1 MARCH 1999
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 454 CID, Mercury MerCruiser 502 CID |
| Model Year | 1998, 1999, 2000, 2001 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Marine readers have rated Mercury MerCruiser GM V8 GM V8 454 CID 7.4L and 502 cid 8.2L Marine Engines Service Manual Number 23 5.0 out of 5.0 based on 1 product reviews. Just need the manual. Wrote review. Can't technically review what I haven't seen yet...