SERVICE MANUAL NUMBER 23
CHARGING SYSTEM
System Components
The alternator system consists of the alternator, battery, the ignition switch and the wiring
which connects these components. Refer to wiring diagrams in SECTION 4E.
Periodic Maintenance
CAUTION
Remove all battery cables from battery (before conducting the following check) to
prevent accidentally shorting out electrical system.
1.
Inspect entire alternator system for corroded or loose connectors.
Check wiring for frayed or worn insulation.
2.
3.
Check alternator drive belt for excessive wear, cracks, fraying and glazed surfaces.
Also, check drive belt tension and adjust, if necessary, as explained under “Drive Belt
Tension Adjustment,” following.
4.
5.
Check alternator mounting bolts for adequate tightness.
Inspectslipringendframeflamearrestorscreenfordebrisandclean,ifnecessary,using
compressed air or a cloth. Screen MUST BE clean, or alternator may overheat.
Drive Belt Tension Adjustment
1.
Install drive belt on pulleys and adjust tension as follows:
IMPORTANT: If a belt is to be reused, it should be installed in the same direction of
rotation as before.
1.
Remove drive belt as follows:
NOTE: The upper, right (starboard) idler pulley is the belt adjustment pulley.
a. Loosen 5/8 in. locking nut on adjustment stud.
b. Turn adjustment stud and loosen belt. Remove belt.
2.
3.
Install drive belt on pulleys and adjust tension as follows:
Loosen 5/8 in. locking nut on adjustment stud. Leave wrench on adjustment stud.
NOTE: Belt deflection is to be measured on the belt at the location that has the longest
distance between two (2) pulleys. Normally this location is between the power steering
pump and the belt adjustment pulley. This location will be different on engines with closed
cooling or models without power steering.
4.
Use 5/16 in. socket and tighten adjusting stud until the correct deflection of the belt is
obtained at location specified above.
90-861326--1
MARCH 1999
Page 4C-7
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 454 CID, Mercury MerCruiser 502 CID |
| Model Year | 1998, 1999, 2000, 2001 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Marine readers have rated Mercury MerCruiser GM V8 GM V8 454 CID 7.4L and 502 cid 8.2L Marine Engines Service Manual Number 23 5.0 out of 5.0 based on 1 product reviews. Just need the manual. Wrote review. Can't technically review what I haven't seen yet...