CHARGING SYSTEM
SERVICE MANUAL NUMBER 23
4.
Remove two brush/regulator attaching screws and remove brush/regulator assembly.
b
c
d
a
72823
a - Screws
b - Brush / Regulator Assembly
c - Stud Cover Insulator
d - Tie Strap
5.
6.
Scribe a mark on rear end frame, stator and front end frame to ensure proper
reassembly later.
Remove four screws which secure end frames and stator together.
IMPORTANT: DO NOT insert screwdriver blades more than 1/16 in. (1.5 mm) into
openings (in next step), as stator windings may be damaged.
7.
Separate rear end frame and stator assembly from front end frame and rotor assembly
using two thin blade screwdrivers (positioned 180 degrees apart from one another) at
the locations shown. Use the two slots shown to initially separate units.
b
c
e
a
a
d
72824
a - DO NOT Insert Screwdriver Blades More Than 1/16 In. (1.5 mm) Into Slots.
b - Rear End Frame
c - Stator
d - Front End Frame
e - Scribe Marks
8.
Place rear end frame and stator assembly on the bench with stator downward. Be sure
that bench is clean and free of metal chips. Remove nuts, washers, insulators and con-
denser from output and ground studs.
Page 4C-16
90-861326--1 MARCH 1999
| Categories | Mercury MerCruiser Manuals |
|---|---|
| Tags | Mercury MerCruiser 454 CID, Mercury MerCruiser 502 CID |
| Model Year | 1998, 1999, 2000, 2001 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(1 votes, average: 5 out of 5)
Marine readers have rated Mercury MerCruiser GM V8 GM V8 454 CID 7.4L and 502 cid 8.2L Marine Engines Service Manual Number 23 5.0 out of 5.0 based on 1 product reviews. Just need the manual. Wrote review. Can't technically review what I haven't seen yet...